Is it possible reset password for server?

I have insert password for error in the server ComfortClick.
I have necessary the reset password
Is it possible?

Hello,

With the rapid increase in popularity for the ecobee thermostat, we are wondering if ComfortClick would be able to support this thermostat.

We are looking for basic functions such as read of the current temperature, thermostat mode(heat,cool,off), etc.  

Ecobee uses an open API, https://www.ecobee.com/home/developer/api/introduction/index.shtml

It allows to add a new app under the developer tab and authenticate it.

Using the HTTP device in bOS, you are able to poll some data.

Could you please advise and provide some guidance if using the available devices/functions in bOS the basic values(temperature,mode, etc.) could be extracted.

Thank you,

Calin

Hi, Maybe I don't understand how does it worls, but if I select horizontal sliding bar changes in vertical mode, and viceversa. In other hand if slider is horizontal (I see vertical) change percent type bar from Rising to Falling, or viceversa, it works but if slider is vertical( I see it horizontal) change percent type bar don't do anything.

Regards and Thanks.

I have two wireless Ring Doorbell devices and can access these through the Ring Android or Windows apps. 

I also have a wireless Chinese webcam.

Is it possible to also interface these devices to bOS? How to approach this?

I have a Honeywell Galaxy Flex alarm system in my house. It is fairly dated but works fine. It is connected to my router through Ethernet cable, has an IP address etc. I can access the console and control the system using the Honeywell Android app.

However is it possible to interface to bOS? How are alarm systems interfaced anyway?

Hi,

I'm facing a problem in testing windows bOS client. Actually, the commands are not sent. I've tried on/off light but it doesn't work. 

- I used "Discover" function to connect to KNXnet/IP router.

- I already import ETS file and configure group addresses.

However, it looks like that KNX is not receiving commands from bOS client.

Any suggestions?

In Android client, when I try to add profile, the following error message appears:

"Error importing settings" 

In addition, I tried to access the visualization using web browser, however, after typing login credentials and clicking Enter, the browser refresh the login page only

Hello,

Is comfortclick compability with the DSC powerseries NEO?

I have a Fibaro motion sensor, now i would like to arm it and get a feedback staatus from it, if it´s armed and when it´s breached while armed- if that happens it should send some command to a relay that then would send out a signal. But i don´t know how to do it. Is there any plans to make a generic alarm panel in bOS?

Hi,

Are all SMA sunnyboy inverters supported ?

I'm planning to buy a SMA SunnyBoy 3.6-1AV-40, will this work natively ?