
Enumeration Control with KNX
Please suggest how to use enumeration control in CC Jigsaw.
Like Climate modes (Values: 0-3), Fan speed (Value 1-5), etc.

Goodwe Solar power API/Modbus
Hey,
Has anyone messed with Goodwe solar power inverters or Ezloggers Pro?
I'm trying to display solar power information in our tablets.
Goodwe uses a cloud based service for monitoring.
I found some API info from here http://euapi.sems.com.cn:82/swagger/ui/index#/ but so far I have no luck getting info from the API for my devices. There is a good chance i'm doing something wrong as i've not used API's with bOS that much.
Option 2 is to use modbus, it should be easier at least for me - i'm still waiting for modbus register table info from their support.

Change Image when value change
Hi,
is it possible, to change an image of from object if value raised a defined value?
If yes? How can I do this

how to run a programm cyclically?
I would like to run a program every ten minutes (not a device)
Creating a scheduler with 24*6 time seems not very smart

how to change ip address of controller
I have a different ip address on controller than when I created the account.
And I cannot change it online

modbus write value problem
Hello there,
I'm on the latest Beta, I'm getting an issue since installing with a Modbus device, it's an I/O module but this only applies to the Digital Outputs which operate by setting the corresponding bit for the digital output.
However, despite the program I use giving out the correct value for the outputs I want on, the Uint16 register only changes for a short time and reverts back to the previous value, and doesn't change the device state? on occasions it does work making it all the more confusing, it's almost as if it's reading back the value from the Modbus device? even with "read Cyclically" off.
It wasn't happening before I upgraded, and to make it even more confusing it's not happening on two other similar devices!?
Any ideas?

status in KNX
Hello friends!
I am a beginner with the Comfortclick and I have a simple question about the status of the devices. Where can I configure the status? I just found the parameter value.
The same thing happened to me with other kind of devices like temperature setpoints, shades, and more things...
Thanks a lot!
Haritz

Google Home
I can not connect comfortclick to google home?
IWhen I add a comfortclick to my google devices, it happens that the connection was not successful.
How can I solve this?
What is this about?
With best regards

problems with irrigation task/ max precipitation value
hi
i tried to use your task for irrigation.... no matter with low temperature thresold, while max precipitation thresold doesn't work fine.
Setting the thresold value upper or lower then its input value there is no change of status.
it seems like the input value doesn't update or threre is a failure while reading datalogger values.
For examples if the input value is precipitation last 24 h ( value 2.6 h) thresold becomes false only with 18 h thresold
(no hysteresis is set)

Newest BETA. Jigsaw stopped working
So. I'm of the impatient type and just had to test the recent beta release. 🤣😤
All devices were lost. Just the folders in the configurator was left.
In the add devices dialog just two devices availible. LG and Samsung TV.
Tried the "repair server option" and now the device has stopped working all together.
It responds on ping but gives "error connecting" in the configurator.
Now what? Is it poossible to make a fresh install on the SD card from a PC? Reset button?
Customer support service by UserEcho