Restrict user access to specific devices
1) How to restrict user access to specific devices?
Example: Parents have full access to their home automation system, a child only limited - to devices in his room.
2) Is there a way to know username who did specific action?
for example: in comfortclick, I want to see the user who closes the light.
Dlink 932LB Camera in 4G
Dear support,
I have an issue with the Dlink 932LB camera. I configured the camera manually in the BOS server application and I stream the video with following settings: Streaming Mode: directly and MJPEG source: http://admin:fucile@192.168.115.25:80/video/mjpg.cgi
It works perfectly as long as the mobile BOS application (I’m using the last version available per apple IOS) is connected to my local Wi-Fi: I’m able to see the images coming in the application. Instead when the mobile BOS application is connected to the server via 4G the camera image shown is completely dark (I don t see anything)
The strange think is that I’m using with the same configuration in the BOS server another camera (It’s a Grandstream model GXV 3610 FHD) and it works both when the BOS IOs application is connected in local WiFi or in 4G
Can you help me to solve the problem?
Regards
Marco
Remote Access to bOS Configurator
Hello,
How do i get access to Jigsaw KNX which is at the site through bOS Configurator from my Office Network or Home Network?
Percentage value of ligths not changing, always at 0%.
All of the dimmer lights stay at 0% so I can not use a boolean as a toggle switch (ON/OFF). The ligths work but I am using a led dimmable light that does not support dimming from the switch (if I gradually increase it to any value below 100% it blinks) and instead uses a remote. I would like to set a boolean value and control it from the client/echo device.
Satel connection problem
Hi,
I can not connect to Satel (via ETHM-1 PLUS). This is my configuration:
How to use showpanel
Hello,
I would like on the bOS iOS client to be able to run a program AND open another panel while pressing a button.
Since a button can only perform one task (?), I built a program that is triggered by this button, and at the end of the program I'm having a "showpanel" command to open the other panel.
However, the panel doesn't show.
What did I do wrong ? Is there something I'm missing about the showpanel command ?
Is there a better / easier way to do what I would like to do ?
Thanks,
François
Sonos display problem when players are grouped together
Hello,
I have 5 Sonos players. When they play different musics, all is fine. When I group together some players, only one of the players continues to display the title and the album picture correctly. The other ones do not display picture anymore, the title is wrong (it is the title that was previously played). The track time is also incorrect.
I often get the "Cyclical reference detected" on one of the Sonos devices, but this might not be linked to the above issue.
Thank you for your help,
François
Controllers
Dear Sirs,
I can't see my controllers to my profile in the controllers section. What can i do about this?
Free space on disk and more ...
How can i see free disk space for Jigsaw controller? (very useful: CPU temperature / load, free / load RAM, bad block for microSD, uptime ...)
Many thanks!
z-wave water detector- Controller 1 cannot be set to Association Group 1
Hello,
I have a z-wave water detector for which the Controller 1 cannot be set to Association Group 1, therefore the alarms and device status are not communicated to bOS.
I have tried several times to restore sensor to the factory default settings, include, exclude, delete then click discovery, soft reset the controller, wake up the device, run Refresh Configuration from the Functions tab.
Am I missing something? Do I have any other options on having the Controller 1 set to Association Group 1?
Thank you,
Calin
Customer support service by UserEcho