Hello, Best regards

I have a grinder black connected to unifi switch, with a vlan set to automation and a KNX IP interface connected the same vlan both with static IP fixed, I follow each step to configure bOS server but the server not connect to IP interface. Show the message: Devices|KNX\garage\lights on/off\c13_garage_rail No response: Read0/0/20 Devices\KNX\GARAGE\lights on/off  

have any of you ever had this problem?

I would like to know if could comfortclick  read my project from a house with 3 floors ? 

In this house I´m using two line couplers, connecting first floor to second and second to third

I have a push button in level one that connect with actuator on level two, they are conected through a line coupler. Does Comfortclick read this information and make it work ?

Hello everyone.

I know there are already posts about it, but I don't see a problem similar to the one I currently have in any of them.

I have a Jigsaw connected to KNX by bus cable.

The problem is that sometimes due to power outages the Jigsaw and the KNX bus go down and not always but on certain occasions when both systems are up. the Jigsaw is not capable of lifting the link with KNX indefinitely and the only solution that can be applied is to restart the Jigsaw and at that moment it raises the link between both systems again.

Is there any way through a program, task or function that allows forcing to deactivate and reactivate the knx connection when it detects that the link is down? Or failing that, to be able to send some kind of Jigsaw restart through some function that “wakes up” the connection with KNX?

Thank you

Hi I'm having trouble connecting to KNX devises. I'm using Jigsaw, created a KNX devise and set  Connection Type 'Jigsaw', enabled the devise and it says connected.

Successfully imported the ETS file, the devise 'Hall Light' says not connected.

Any guidance / pointers would be much appreciated?

Hello.
I have problem with ETS 6 returning error on bus test, when I try lets say IP interface it is working fine. But both interfaces works with ETS 5

Hello

I have a Hormann Garage Door with Hormann KNX Gateway where I have option for going Up and Down.

For this I create two buttons. One for Up and one for Down. When I press Up button I set show confirmation to true and I added a pin to avoid Garage Door opening by mistake since from there you can enter directly in my house.

These is my confirmation setting.

When I press button bellow confirmation appear 

Now come my problem.

If I put the pin everything is working fine and door is opening

If I press cancel (X button from right up corner) dialogue gone but instead to have same Garage Panel it go at main Panel.

So in case of aborting I should remain in same page.

Any idea if this is a bug and how I can fix it?

Best Regards

Valentin

Is there a way to attach some actions on triggers for KNX devices (i.e. trigger something if knx button writes to knx light)?

I want to add some extra behavior on second click like if lights are on and somebody click the button again switch on even more lights, etc.

When I try to import KNX project exported from ETS5 as .esf extension Addresses are correct as in bellow image

When I try to import KNX project exported from ETS5 as .knxproj extension Addresses are not correct. Please see bellow image.

I use bos configurator 4.9.1.

Is this a bug?

From last week all the settings off the light have changed suddenly. Some lights doens't work any more and others don't do what I want them to do. I can't even login. What is happening?? 

Hello,

I would like to implement a 4-priority load control. I have a KES-PLUS installed on the system. I have a 4-channel actuator that would handle the loads to be disconnected. how can I do?

Thank you