0

Unconfigure access to KNX project configuration

UCV DOMO 3 months ago in Devices / KNX updated by Ricardo Pinto 3 months ago 1

Hello. 

Is it possible to restrict access to configure the KNX project through a Jigsaw via configuration to reactivate it when you need to configure something?

+1

Hi,

Do you mean, prevent access to ETS via the Jigsaw programming interface?

Yes, it's possible, as long as you are using the Jigsaw as the only programming device on the installation.

Building > General > Jigsaw

Disable the KNX IP Server, and it's done, you can't connect to ETS anymore.

This way, you can access the Jigsaw Configuration, and reactive the access through ETS only when needed.

Don't disable the KNX Driver, or you'll stop the connection from the Jigsaw to the BUS.

Just disable the KNX IP Server whenever you want to protect the access to ETS programming.

Best regards,

Ricardo