Hi,

I want to reduce the maximum brightness (of lights in a group) to 50% instead of 100% during night.

Anyone an idea how to configure this?

Hi Everyone !

When I try to connect via https, the web browser shows a warning message (SITE NOT SECURE).

Is it a meaning to avoid this warning ?

That's not user friendly for the final user.

Thanks for your help.

Claude.

Hello,

I'd like to use the night mode in the buttons (light up and night).

and at the same time i wan't to have the lighting in the bedroom area (toilet, bedrooms, halway,..) to work at ca. 40%.

All lights are DALI dimmable. 

I made a group 3/3/4 night buttons where i put the 4(general) LED - brightness mode in.

What do i have to do in bosconfig for the nightmode buttons and what for the lights to go max. 40%?

Thanks,

Hi dears,, 

I have an important question,, so plz help to answer it,, 

I have hotel project,, the owner needs to know if the rooms are (occupied / empty) as a simple solution, using a KNX 4 binary input modules,,

so my question is can i integrate these knx modules with jigsaw, to read/know each room status as (occupied /empty)?? 

Note: in this KNX system,  I will use KNX Power Supply and KNX 4 binary input modules.. 

Regards,, 

Aladdin Sultan 

I have some some dimming lights (controlled buy dali gateway), they are programmed in ETS and working fine.

Now i'm trying to control theme with comfort click without succes.

I have the following adresses:

3/4/0 switch (switch)

3/4/1 dimming (dimming control)

3/4/2 value (percentage 0-100%)

3/4/3 status (switch)

I used in comfort click the following adress:

Address: 3/4/0 switch

status address: 3/4/2

resutl:

the slide goes directly back to 0

the light does nothing 

Hi, I have the system ABB for Hotel access control

The system ABB used two group address and they are proprietary telegrams

If the composition is known is possible to read the telegram?

Do you have one exemple?

Best regard

Giordano

Hi, I would like to use the function "ChangeStationByUri(stationName, streamingUrl)" in the sonos system

Do you have the example?

Best regards

Giordano

Getting this when I try and open node setrtings in newly included device (Fibaro twin relay).

Hello,

The http device stopped after few months working without any issues. Here is the debug message while trying to send the command:

Debug : 10/26/2018 19:45:41 : Devices\http : Exception : GetResponseCallbackWebException : The underlying connection was closed: An unexpected error occurred on a send. at System.Net.HttpWebRequest.EndGetResponse(IAsyncResult asyncResult)
at BOSCommon.Drivers.BOSHttpClient.GetResponseCallback(IAsyncResult result)System.IO.IOException: Authentication failed because the remote party has closed the transport stream.
at System.Net.TlsStream.EndWrite(IAsyncResult asyncResult)
at System.Net.PooledStream.EndWrite(IAsyncResult asyncResult)
at System.Net.ConnectStream.WriteHeadersCallback(IAsyncResult ar)

The encoding is UTF8 and parser type Json. 

Same command gets executed when it is launched from google chome browser from the same server where the bOS is installed.

Could you please advise what the problem should be? 

Thanks,

Calin

Hi there friends,,

I’m new to comfortclick and I’m trying to add Fibaro controller (HC2) in the software to control the Fibaro devices already in the HC2.

Can you please help and guide me on how to do that?

Your help would be highly appreciated