Hello,

I have a SMA tripower 5000-TL20 inverter with a build in networkcard. Is it possible to connect them with the jigsaw?

Witch password do you need to fill in?  

Did anyone integrate  Arlo security system into BOS? 

Hi

Reading the manual of your Colibri, I see the following warnings:

• Always shut down Colibri properly by shutting it down in bOS Configurator.
• Don't shut down Colibri by unplugging it from the power supply.
• The use of UPS is recommended.

Obviously we always protect our systems with a UPS, but What would happen if there is a power failure that lasts longer than the capacity of the UPS? Will the system work again? ... Will it have to be restarted manually?

If we automate that shutdown, how does the Colibri automatically turn on when the power returns?

If you have a solution for this case, please show it to me to apply it to my next projects.

I do not know if you have it planned, but I think you should integrate a small battery inside that automatically makes a soft shut down when detecting power failure... and of course, it will restart when the power returns.

I would greatly appreciate a response as quickly as possible, since it gives me a little "fear" to install it to one of my clients and one day that happens to him and nothing works at home.

Thanks Greetings

Pablo López

Hello ,

I am having a question regarding Pop Up Alarm messages for Hotel rooms. We have a KNX project for a hotel and we have install a Sledgehammer Server. We have create the Users such as Reception and Room's Users . Inside each Room we have 3 different push buttons for 3 different alarm functions which are: Do not Disturb , Make Up My Room and Room Service. What we need to do is anytime the customer of each room when pressing one of these buttons the Reception will receive a pop Up Alarm message on the screen . I have tried to make this configuration but I didn't get any pop-up messages when pressing on of these three buttons. Any ideas how we can make this work? 

Hello. In last 4.5.8 version of bOS I noticed "bad UTF encoding" in KNX import section. In our language we use lots of accent word and in past version it was fine but in last it is doing this:

Maybe I am missing some settings but I have country set to SK and also user language to Slovakian. 

Hi,

I am trying to integrate a Grünbeck Softliq SC18 water softener using HTTP POST, but for some reason I can't get the response values back.

bOS sends the POST command correctly and the response is what I would expect from what I can see in the packet capture. The problem is apparently bOS doesn't like the response and doesn't store it. There are also errors in the log, but I don't know what they mean.

What am I doing wrong?

Thanks

Sebastian

packetcapture (3).cap

In the new BOS version (4.5.x) is it possible to group speakers.

Is it also possible to ungroup speakers?

Example: group speaker 1 + speaker 2 to group 1 and then ungroup group 1 to speaker 1 and speaker 2.

Hello everyone

after  bOS 4.5 update the ip cameras no longer working and streaming !

any ideas ?

Dears Support,

I discovered a ModBus bug in the new version 4.5.5: after few hours the modbus communication driver stops to work. In order to restart you need to reconnect to the server with the configurator toll, select the device modbus deactivate and enable again… after it starts to work again for other hours before stop again

I also tried to restart the server again, but it didn’t solve the problem

Can you have a look on the modbus part of the new server version please?

Regards

Marco

Anyone no how connect a solar inverter kostal with confortclick?

It have a rs485 port but no communication with confortclick. 

Can anyone help

Thanks