Hi all 

I have a time node that works and displays time in the visualisation correctly. Problem shows up when i want to send time variable to KNX address and show it on the switches, it always stays at 00:00.

Addreses are the same 0/0/1  and 0/0/3 on switches.

Hello. I have a shelly 2.5, from which I use a channel to light a lamp. I would still like to use that channel from a knx switch, through the jigsaw server. How could I do this? I managed to give the KNX address the value of the channel, but I can't do the opposite. Thank you in advance for your answer.

Im having problems with connecting to comfortclick jigsaw in ETS to program devices.

IP is correct, NAT on or off doest make a difference.

Hello,

Does anyone know if /how ze can change the Min/max value of the tilt angle of Homekit ? I would need 0 to 90°

Thanks

Hello,

Do you know if there is any AC manufacturer which provides his AC units with a local / open source API which allows them to integrate with bOS Comfortclick and control by wi-fi, like Daikin did in the past? I can just see that Daikin removed their local API so I am looking for any other solution.

after updating firmware Colibir controller not connecting with configurator what to do is firmware crashed?.... what to do

Hello,

why is there not a "name" field to be entered and shown in the server list ?

And there should be more detailed error messages when connection fails, i.e. there is no way to know if the server is offline, if the login information is wrong, etc...

Hello,

is there the way to set integer numbers with negative values? (standard keypad has no "-"minus symbol

Thanks

Hello,

is there the option to change decimal separator "." with ","?

Thanks