I'd like to control some Hunter Douglas PowerView blinds and I'm curious if anyone has figured out how to do that.  I'd appreciate your ideas.

Michael

I've successfully connected to an IP Camera using bOS.  Now, I'd like to be able to show it on an Amazon Echo Show, but it doesn't look like Alexa Skills support showing IP Cameras.

Has anyone had any luck doing this?

Thanks,

Michael

Hi,

I've found a minor bug with the function "PIN code for locking the access to function" on controls.

Scenario:

My first theme panel is Home. And I also have a separated panel group, called Zones, and inside that panel group I have my house compartiments.

On the first it's Hallway. On the third it's Living room.

In each of this panels, I have certain controls where I've set a PIN code for locking the access to function of those controls for testing (e.g. hallway light and living room light).

When entering Zones panel, it goes to the last panel I've used (Living room). So far so good.

In Living room panel, I touch the PIN code protected living room light. It asks for PIN code. I decide not to enter the code, and press the upper right cross. It goes back to my Home panel. Strange...

Let's say that I enter again on Zones, it goes to Living room. Then I press to go to Hallway, where I touch the PIN code protected hallway light. I press the upper right cross of the PIN panel, it goes back to the Living room panel. Strange... Either way, while I was sent back to the Living room panel, if I try to do the same on the living room light, then I'm sent back to the Home panel as previously stated.

So basically, exiting the PIN code panel, doesn't save the last panel visited.

Best regards

Hello,

I restored and old configuration made with other computer to a new computer and everything seems to be ok.

But when I launch the Client I get the following error:

"Can not connect with this profile. Profile key does not match

the server key. Possible security violation. "

I re-instaled everything and deleted everything but I still cannot launch the Client.


I have also removed the controller from my account in order to add it again.

Could you help ?

Thank you

I´m trying to import a 3 byte status value that needs to be put through the bit converter. Altough the only option I find is to import it as a date or time value. How do I add it as a generic 3byte value?

I´m trying to use Thermostat Task but I would like to Change Setpoint Temperatura with a KNX Value, is it possible?

Thank´s to All

Have anyone any idea why i have this message? 

Hi

Clicking on the z-wave "Node Settings" button for a device in Devices\Z-Wave brings up the script error message shown below.

This happens for all z-wave devices. I'm running bOS on a Jigsaw device, configurator on Windows 7 and all are fully up to date with latest ComfortClick releases. I can access and browse the internet from my PC. Can you help please? 

Contém uma