1. Hello, I have a problem with the product license. I have a GRINDER server at home. When I enter the "BOS CONFIGURATOR" in Building --> License: it is revoked. I can not program anything, the KNX device appears as: connection error. I can not see the settings of the KNX device, nor any other device that I had previously configured as SONOS. I could have help in this matter, thank you very much.

  CARLOS ALBERTO

good morning
Has anyone of you integrated a MOBOTIX T25 camera / video intercom?
If so, I would like to know how.
Grateful in advance

Hi,

I my theme, i use several painels. And some of theme says it has error but everything works. In "Erros" appears old variables (with different names). How can i solve it?

Good Morning.

Has anyone done integration of Comfortclick with nobreak?

Thanks a lot.

Hello. I have an issue with counter log graph. I set it to log power consuption from KNX. At start it went fine but after end of the hour and start of the next hour I noticed it stop count. So I decide to reboot Jigsaw to maybe fix the issue but after end of another hour it stops again. 

I am having problems when trying to connect to my Jigsaw. The device is new, but it would not allow me to access as the manual instructs to do. I am typing User (USER) and Pass (Password) but the bOS Configurator would send me a warning telling me it could not connect to the device and warning me about a possible security violation.

I would like more information or help on how to solve this problem.

Hey!

Has anyone used this gateway with bOS? I'm trying to read out mbus (W.water, C.water and heating) meter values with bOS from the anybus gw, in anybus I can read the meter values and it has no problems with the readout. But in bOS I can't get the correct values to show. Scaling should be correct (0,001 for the water and  0,01 heating), i have tried almost all register numbers but none of them seam to display the correct values. 

Settings for the w.water meter, register address should be 130 or 150, but it gives constant 0 for value, with 149 I get a response 16,017 but it's the wrong value.

Modbus GW settings

Anybus meters with register numbers.

Any ideas what am I doing wrong?

Hello,

I have question about the configuration of Alexa in french .

I managed to control a light knx (on / off, variation) but for the doors or roller shutter, I can't get the controls are always "on" and "off" and not "open" or "close".
however, I put in "Alexa Display category" the value "DOOR" instead of "LIGHT". The link knx is made on the property "Power Reference" is this correct?
Do you have documentation on the configuration and associated commands?

Best regard

Hi,

how is possible to lock button or other controls according to the addition condition (bit, boolean ...).

regards

Hi!!!  I have a problem with yahoo weather services. When I program my server I received weather data, now it doesn´t work.  It´s possible that I need to open some ports to work?

Thank´s to all!!!!!