I've just connected my SMA Inverter (SB3.0-1AV-41) using the ModBus protocol. Connection was made successfully, but all I retrieve from fetching values is -1 or synonyms (65535 for uint16, 4294967295 for uint32,...). 

I have some ModBus information on this specific inverter ( modbuslist_en.html), and I've tried to crosscheck this with the (slightly outdated) SMA-Modbus example on the Library, but no dice... I cannot read out values from my Inverter and start building my Solar dashboard... 

I'm using the bèta of bOS 4.8.0 and these are my settings for getting the value of Phase A, address 199 in the SMA datasheet, so I use 198 in bOS;

Advise or tips?

Hi, I saw this topic: Solar Edge - Smart Home Building Automation Software - ComfortClick bOS 

But i'm unable to get it working/connecting. Is there some feedback or manual available to further troubleshoot this?

It doesn't seem to work via API calls. 

Thanks in advance.

Hello everyone,

Hope that everyone's safe.

I'm looking forward to test a certain device, that's supposed to be connected to a RPI under the UART interface (+5v GND RX TX).

As I'm not even risking voiding the warranty of the Jigsaw, I was looking for any kind of USB adapter that would allow me to connect the UART interface of the device, to a USB on the Jigsaw, and therefore try to use the "Basic" device to see if something happens, and try to do the integration.

Most of the adapters I see on the internet refer drivers, etc. I was looking for something more straightforward, as I just want to connect via USB to the Jigsaw.

Any advise? Anyone ever used this kind of adapter on the Jigsaw / Grinder / Whatever?

Best regards

Hi I would like a hand creating this API for aTank Sensor Called Tankutility

i would like to read the volume value and temperature value from comfortclick GUI

i am following this API Guide ( API Guide) how ever i am only able to get the Token Value under Response Value line

here is a picture of where i am stuck right now

Hello, does anyone know why the 3671 port doesn't work anymore on Bos controller even if there is a port forwarding? I need this for remote programming my KNX installation. It was working good so far since know. Also when the Bos configurator inform me  that i need to update my controller when the window prompt me to, there is no update available.  

Thanks in advance.

Dimitris

After power failure bos has wrong time. How to fix it?

Hello, I have all my KNX devices at home connected via BOS to Alexa - about 92 devices. All worked well, until suddenly Alexa stopped responding to all devices. i.e. - When I ask Alexa to 'turn on' a device, it says that the device is not responding. 

To clarify, BOS works well from the app and also Alexa works well with other devices not connected via BOS. 

Any help please?

Is there any way to reset configurator data and restart with a clean configuration?

Im starting with a free licence, to try this system but somehow got an error saying that there were too many users (>1).

Now I can't access Configurator even by re-installing software!

I found configuration files (import/export of bOS tree) are kind of binary format. Is there any way to manage them outside of the bOS Config application? Especially the HTTP device which I'm interested in. I would like to generate automatically the configuration of the HTTP device and import it straight into bOS Config.

i have MCOHOME zwave thermostat, and i have 2 different models i try to add it in BOS after adding i didn't get fan speed control except on that others are ok. 

please help.