All of the dimmer lights stay at 0% so I can not use a boolean as a toggle switch (ON/OFF). The ligths work but I am using a led dimmable light that does not support dimming from the switch (if I gradually increase it to any value below 100% it blinks) and instead uses a remote. I would like to set a boolean value and control it from the client/echo device.

Hi,

I can not connect to Satel (via ETHM-1 PLUS). This is my configuration:

Hello,

I would like on the bOS iOS client to be able to run a program AND open another panel while pressing a button. 

Since a button can only perform one task (?), I built a program that is triggered by this button, and at the end of the program I'm having a "showpanel" command to open the other panel. 

However, the panel doesn't show.

What did I do wrong ? Is there something I'm missing about the showpanel command ? 

Is there a better / easier way to do what I would like to do ? 

Thanks,

François 

Hello,

I have 5 Sonos players. When they play different musics, all is fine. When I group together some players, only one of the players continues to display the title and the album picture correctly. The other ones do not display picture anymore, the title is wrong (it is the title that was previously played). The track time is also incorrect. 

I often get the "Cyclical reference detected" on one of the Sonos devices, but this might not be linked to the above issue. 

Thank  you for your help,

François 

Dear Sirs,

I can't see my controllers to my profile in the controllers section. What can i do about this?

How can i see free disk space for Jigsaw controller? (very useful: CPU temperature / load, free / load RAM, bad block for microSD, uptime ...)

Many thanks!

Hello,

I have a z-wave water detector for which the Controller 1 cannot be set to Association Group 1, therefore the alarms and device status are not communicated to bOS.

I have tried several times to restore sensor to the factory default settings, include, exclude, delete then click discovery, soft reset the controller, wake up the device, run Refresh Configuration from the Functions tab.

Am I missing something? Do I have any other options on having the Controller 1 set to Association Group 1? 

Thank you,

Calin

Hello,

I 've got problem to connect 2 IPads to grinder via bOS Client.

Only one is connected, the other one can't connect.

Server is updated 4.4.0 to 4.4.2: same problem.

IOs is updated 11.3: same problem.

Profile deleted and recreated: same problem.

App deleted and reinstall: same problem.

IPads had the same name, rename in App settings: same problem.

IPads are true in the local network but false in online.

How many connections are possible with the same user?

if i create a different user, will it works ?

Any ideas of the problem ?

Regards

Gauthier

Hi,

Let's say I have a Schedule task for a certain object.

Is it possible to set the Time events for that Schedule task using RPC?

The use case for now is not important, I'm just trying to develop an idea with bOS + Tasker (Android).

Best regards

Hello, again. I have just make an integration and I had an issue. One step was programming KNX devices (via USB), then plug Jigsaw , all correct, then I added new KNX devices and when one KNX device was in programming mode (OA 15.15.255) I was unable to program them ETS said two devices in programming mode, I unpluged Jigsaw from KNX bus and then it works. It just happened with OA 15.15.255, then I tried with a device with OA asigned in programing mode and there was no problem.

If I check devices in programing mode with ETS, without any device in programming mode, there no one, but if there is new device (OA 15.15.255) then ETS detect two devices in programing mode (if Jigsaw is plugged).

Regards.