Hey,

Has anyone messed with Goodwe solar power inverters or Ezloggers Pro?

I'm trying to display solar power information in our tablets.
Goodwe uses a cloud based service for monitoring.
I found some API info from here http://euapi.sems.com.cn:82/swagger/ui/index#/ but so far I have no luck getting info from the API for my devices. There is a good chance i'm doing something wrong as i've not used API's with bOS that much.

Option 2 is to use modbus, it should be easier at least for me - i'm still waiting for modbus register table info from their support.

Hi,

is it possible, to change an image of from object if value raised a defined value?

If yes? How can I do this

I would like to run a program every ten minutes (not a device)

Creating a scheduler with 24*6 time seems not very smart

I have a different ip address on controller than when I created the account. 

And I cannot change it online

Hello there,

I'm on the latest Beta, I'm getting an issue since installing with a Modbus device, it's an I/O module but this only applies to the Digital Outputs which operate by setting the corresponding bit for the digital output.

However, despite the program I use giving out the correct value for the outputs I want on, the Uint16 register only changes for a short time and reverts back to the previous value, and doesn't change the device state? on occasions it does work making it all the more confusing, it's almost as if it's reading back the value from the Modbus device? even with "read Cyclically" off.

It wasn't happening before I upgraded, and to make it even more confusing it's not happening on two other similar devices!?

Any ideas?

Hello friends!

I am a beginner with the Comfortclick and I have a simple question about the status of the devices. Where can I configure the status? I just found the parameter value.

The same thing happened to me with other kind of devices like temperature setpoints, shades, and more things...

Thanks a lot!

Haritz

I can not connect comfortclick to google home? 

IWhen I add a comfortclick to my google devices, it happens that the connection was not successful.

How can I solve this?
What is this about?

With best regards

hi

i tried to use your task for irrigation.... no matter with low temperature thresold, while max precipitation thresold doesn't work fine.

Setting the thresold value upper or lower then its input value there is no change of status.

it seems like the input value doesn't update or threre is a failure while reading datalogger values.

For examples if the input value is precipitation last 24 h ( value 2.6 h) thresold becomes false only with 18 h thresold

(no hysteresis is set)

Hello,

I've got several Global Caché iTach devices. 

I'm getting the following error messages a couple of time every day, at random : 

"Error connecting to device"

"Device is connected"

This is just a 1 minute disconnection, but when this is happening when I want to trigger an IR command, that's a disaster : it's not working, and users get very irritated. 

Any ways to fix this ? 

Please note that I was using before another smart home box, and I didn't have any issues at all with the Global Caché. 

Thanks,

François 

Hello,

I looking for a way to activate a scene from Comfortclick with a KNX-pushbutton in a project that i'm working on.

Any ideas how i can use the button as a trigger for a scene?