Hey,

Is there a model list, as what models are supported? I couldn't find it. 
I have a LG 55SJ850V at home and this did not connect to it. 

Hello,
In the configurator, I have imported and updated a backup of an old password-protected project that I do not remember.
How can I access the configurator to update the demo project?
Thank you

Has anyone had any luck in configuring these door windows sensors?

https://szneo.com/en/products/index.php?id=42

I have added them via the inclusion button in bOS configurator (jigsaw with z-wave dongle). They start configuration when I follow the instructions but ends up as "NotConfigured"

Associations are also blank. No values are read.

After a bad manipulation I supposed The configuration is loading for ever.

I did the following to try to solve

- uninstall of bos configurator and bos server

- restart my computer

- reinstalled

It didn't help.

Hey,

Has anyone messed with Goodwe solar power inverters or Ezloggers Pro?

I'm trying to display solar power information in our tablets.
Goodwe uses a cloud based service for monitoring.
I found some API info from here http://euapi.sems.com.cn:82/swagger/ui/index#/ but so far I have no luck getting info from the API for my devices. There is a good chance i'm doing something wrong as i've not used API's with bOS that much.

Option 2 is to use modbus, it should be easier at least for me - i'm still waiting for modbus register table info from their support.

Hi,

is it possible, to change an image of from object if value raised a defined value?

If yes? How can I do this

I would like to run a program every ten minutes (not a device)

Creating a scheduler with 24*6 time seems not very smart

I have a different ip address on controller than when I created the account. 

And I cannot change it online

Hello there,

I'm on the latest Beta, I'm getting an issue since installing with a Modbus device, it's an I/O module but this only applies to the Digital Outputs which operate by setting the corresponding bit for the digital output.

However, despite the program I use giving out the correct value for the outputs I want on, the Uint16 register only changes for a short time and reverts back to the previous value, and doesn't change the device state? on occasions it does work making it all the more confusing, it's almost as if it's reading back the value from the Modbus device? even with "read Cyclically" off.

It wasn't happening before I upgraded, and to make it even more confusing it's not happening on two other similar devices!?

Any ideas?

Hello friends!

I am a beginner with the Comfortclick and I have a simple question about the status of the devices. Where can I configure the status? I just found the parameter value.

The same thing happened to me with other kind of devices like temperature setpoints, shades, and more things...

Thanks a lot!

Haritz