Hello,

I need to control 10 zones of watering with the following parameters:
- to switch on them for a certain period of time with the ability to change it

- selected devices should switch on one by one with a delay. 

For example, I select in Scene  "zone 1" and setup the timer for 10 minutes, "zone 5" setup the timer for 5 minutes and "zone 6" setup the timer for 10 minutes, so in overall my Scene should run for 25 minutes. I would need to run it in sequence "zone 1" after 10 minutes switch off and with 2 minutes delay start "zone 5" after 5 minutes switch off another delay for 2 minutes and switch on "zone 6" for another 10 minutes.

As I'm a newbie so any help would be appreciated and thank you in advance everyone.

Hi guys,

For the PIN part of the Confirmation Dialog is there a way to have it as a variable? So if you want to change the PIN you change in one place instead of going through all the dialog boxes and update it.

Than you,

Calin

Hello, 

Why if WRITE INTERVAL is 1 second, the data stored is 10 seconds wroten?

Hi guys,

The default baud rate comes as 9600 for the DSC IT-100. Do you have any tips on how to change it to 19200 for virtual keypad? 

Could it be done using the key pad PK5500?

Thanks,

Calin 

Hello everyone

Is there any possibility to make the Comfort Click check the online status of the elements of the KNX bus?

heartbeat?

Hi,

Did anybody tried to integrate bOS in HomeAssistant or inverse?

Newly installed bOS configurator and connected to Colibri. When i enter the access ID and kept username & password default, but its showing error to connect server.

Hi I'm having trouble connecting to KNX devises. I'm using Jigsaw, created a KNX devise and set  Connection Type 'Jigsaw', enabled the devise and it says connected.

Successfully imported the ETS file, the devise 'Hall Light' says not connected.

Any guidance / pointers would be much appreciated?

Good day.

Is it possible to use a second network card in the ComfortClick server for communication with an additional KNX router? I’m supposed to control 4 villas. Each will have a separate network. But each villa must have access to additional IP router that will support external lighting (common garden for all villas).

Regards,

Grzegorz Kulinski

I need to be able to receive the video door entry call in comfortclick.

How can I send such a call to a sonos? 

I'm using comfortclick library file for this case. I supose the way is here but I'm unable to configurate it.