Hi,

I've found a minor bug with the function "PIN code for locking the access to function" on controls.

Scenario:

My first theme panel is Home. And I also have a separated panel group, called Zones, and inside that panel group I have my house compartiments.

On the first it's Hallway. On the third it's Living room.

In each of this panels, I have certain controls where I've set a PIN code for locking the access to function of those controls for testing (e.g. hallway light and living room light).

When entering Zones panel, it goes to the last panel I've used (Living room). So far so good.

In Living room panel, I touch the PIN code protected living room light. It asks for PIN code. I decide not to enter the code, and press the upper right cross. It goes back to my Home panel. Strange...

Let's say that I enter again on Zones, it goes to Living room. Then I press to go to Hallway, where I touch the PIN code protected hallway light. I press the upper right cross of the PIN panel, it goes back to the Living room panel. Strange... Either way, while I was sent back to the Living room panel, if I try to do the same on the living room light, then I'm sent back to the Home panel as previously stated.

So basically, exiting the PIN code panel, doesn't save the last panel visited.

Best regards

Trying to create a button that opens a form panel.

I've created my sub-panel, but when I select "Enable Form" and "Form Panel" in the master screen, it asks me to "select path" and I have no sub-panels listed to choose from.

Where must the sub-panel be located in the heirarchy to show up?