1. ComfortClick
  2. bOS Configurator
  3. Devices
  4. Z-Wave
  5. Bugs
0
Under review

Qubino integration Problem

Miguel Paredes 5 years ago in Devices / Z-Wave • updated by ComfortClick Support 5 years ago • 1

I am having problems adding correctly a qubino Flush 1 relay module(ZMNHAD3) it can be added to BOS with no problem, but i can only control the relay and view watts reading. but it will not show binary sensors status and will not show any temperature data ( i have the temperature Sensor already and works find in other controller). also i am having problem to add the parameters manually, everytime i would like to set the parameter it display "index outside the limits of the matrix".

Under review
ComfortClick Support 5 years ago

Hello,

do you have the association groups set correctly? When adding a parameter, first try to add the number of the parameter and click Get, close the form and open again. Then try to set to a custom value. The device is currently installed in our office and all the settings and feedbacks are coming trough nicely.

Best regards.

Customer support service by UserEcho