Bugs
0
Fibaro Radiator Thermostat
Fibaro radiator thermostat error message Devices : No response to Battery.
Every hour for each valve.
It is set to: Enable polling
It transmits the battery charge value at the set interval with polling.
But why does it put a No response to Battery error in the LOG?
Customer support service by UserEcho
Hey,
It's hard to say what might be causing this issue. I only have one Fibaro device with a battery, and when it ran out of power, I logged its battery status but didn't see any errors in the logs. But one disconnected fibaro plug is spamming the log after every 5 minutes.
Do you use an analog log to monitor it? Maybe the read interval is different and doesn't align with the polling interval?
Thanks for the answer, I don't know the solution yet, don't you have such a log?
No response to Sensor Multilevel.
No response to Battery.
Have you tried z-wave network heal?
Unfortunately, network heal doesn't change anything.
Have you tried to remove them and add back? Sometimes, excluding and re-including the device in the Z-Wave network can help clear up errors.