Upgarding my KNX with RF modules

2 months ago in General • updated by 2 months ago • 1

I want to upgrade my installation with RF modules: RF-AKK2UP.01 + RF-LK001.03 for conecting some additional decorative lights which dont have their own dedicated power line connected to KNX.

My ETS requires connecting RF-LK001.03 to the TP branch. But I have everything on the IP branch in ETS via Jigsaw.

Is it possible to connect RF-LK001.03 to the existing installation (on Jigsaw), or do I need a separate TP branch with a new TP interface? If it's the case I need two seperate branches (TP and IP) is it possible to comunicate between the two?

Thanks for the answer!

Vote

Replies 1
Oldest first
- Newest first
- Oldest first

2 months ago

IP gateway still uses TP - Twisted pair. The RF gateway has to connect to it so the existing system can see/control it. You still need to configure the filter table so only the correct RF group addresses are used and it wont be overloaded with useless info it does not need to see. Once everything is configured in ETS you import the group addresses the same way as you did with regular TP devices.

Customer support service by UserEcho