0
Completed

date and time on knx

luca di giorgio 7 years ago in Devices / KNX updated 7 years ago 8

Hello

I need to write cyclically on knx the actual date and time. I want to use these values to set them on a meteodata theben not equipped with gps in order to calculate the sun position for shading my building. 

It is not possible to write value directly from GENERAL/TIME NODE, so

i've set a device DATE and a device HOUR with their knx addresses , but device date doesn't update since i set his initial value while the device hour changes but is different from the system value.


Can you help me?


Regards



GOOD, I'M SATISFIED
Satisfaction mark by luca di giorgio 7 years ago
Under review

Hello,


try adding Date and Time node under your KNX drive in bOS and link them to correct group address and it should be working.


Regards.

hallo

here are some pictures of my Bos configurations

node date and hour are ready but their value is not up to date ( the date is the last date since i've set it, the hour is different from the system hour that you can on windows bar at the bottom of the image

regards


ora.tiffdata.tiff


Hello,


could you please provide TeamViewer information and we will try to resolve the issue.


Best regards.

teamviewer connection send  toComfortClick Forum <support@comfortclick.com>


regards

Hello,


we've managed to resolve the issue, simple node re-add fixed the problem.


Regards.

Perfect . Thanks

hallo

i've still the same problem

re add node but values are not up to date (time is 0:00:00 and date is 01/01/2010)

i've to set them manually, but then they are fixed


regards