Your comments

How do you connect to KNX, by USB or IP? if is IP what sort? Tuneling ,routing ? have you checked that both devices are in the same IP range?

Regards

Are you usink KNX or not?, if you don't use KNX you must disable KNX device.

Regards

As far I know the Arduino library do it by himself, if you have select the Sony device command is sended three times.

If you wanna send manually make a task with a trigger and place a delay between the command call.

Regards.

Mhhhh maybe I don't understand the question, but those commands are differents:


A90
Decoded SONY: A90 (12 bits)
Raw (26): 2400 -600 1200 -600 600 -550 1200 -600 600 -600 1150 -600 600 -600 600 -550 1200 -600 600 -600 550 -600 600 -600 600 
A90
Decoded SONY: A90 (12 bits)
Raw (26): 2400 -600 1200 -550 600 -600 1200 -600 600 -550 1200 -600 600 -550 600 -600 1200 -600 600 -550 600 -600 600 -600 600 

Is just for information, I would like know the memory that i need for a big project, current project has 4122 nodes, at this moment, and there are 32 thermostats for source 1 and other 32 for source 2, and many others runtimes and Configurator is coughing, but memory used for BOSService is between 110 and 156 MB I thing is a perfect memory usage. Thanks


Regards

For monitoring network devices on link layer, disable PoE for devices when build is without ocupation........and other SNMP 'things' for example.


Regards

Could you solve the problem?

Go to BOSServiceMonitor and shutdown service, then restart service and you could log in, take care don't trigger again or you will enter in bucle again.

Regards.

At the bottom scrren, left side, there is a status bar that indicates errors, there is a refrerence for a ciclical refrence, similar to a infinite bucle, it could collapse the system a make hang it.