Your comments

Hi Guys,
How is it with the amazon echo? is it working ok?

I'm not sure if this helping you, but did you disable DHCP in het HUE bridge software. In case you've another device set to DHCP server, it will conflict with the HUE bridge.

Hi Jure,
I noticed monitor log was not exported completely, I'll send you complete file as well. And yes, I pressed device 43 very often in short time.
Regards,
Fred

Hi Jure,

I've tested thermostats again, they're still not working. See my details below. This should be OK.
I'll send you the log files by email. Hopefully you're able to find the cause of this problem.



Thank you in advance.

Regards,
Fred

Hi Jure,
OK. I'll provide a log within some days.
All my other devices are working fine, they're all battery powered devices indeed.
I'll keep you updated.
Regards,
Fred

Hi Jure,
Yes, I've tried it several times, also with my other thermostats, currently I've 5 pieces in use and another 7 in a box to install later. I've waited for several hours before checking the new temp. setting, but it only changed after hitting the wake up button on the device itself. When I checked the monitor on same time, then I noticed new setting was being pushed through to the thermostat by BosServer.

Do you need a complete log file maybe? If needed I can create one.

Regards,
Fred

Hi Jure,

I just included another extra thermostat(just for testing proposes) and interval function has not been changed. so default of 300 sec is being kept.

1) I changed temp setting in Bosconfigurator and pressed on function requestvalue()


2) then monitor gives following info.


3) Setting is nog being changed in Thermostat, still old value of 15 degrees is active.

4) after pressing wake button on device the new value of 18 degrees is being shown immediately on display.


5) Monitor is showing this info after pressing the button.


The manual of danfoss is describing when no connection is available.
"If no connection can be made, the alarm symbol and the antenna symbol flashes"

Indeed the symbols are flashing on the thermostat device, but device is working properly except for changing setting point.

Do you need more info or is this sufficient to find a solution?

Regards,
Fred Hartman

Hi Jure,

I've bought some extra thermostats after testing with 1 piece.
Now I noticed the temp setting point is not being send to the thermostat itself, Bosclient is showing new setting, but when I check the display on the thermostat the new setting has not being sent. When I press the wake up button on the thermostat the setting will change to new setting. But not without the manually wake up.
The wake up interval has not been changed in the Bosserver and stil default value of 300 sec.
Could you please investigate this matter?
In case more information is needed please contact me.

I'm using last version of Bosserver 4.2.6

Thank you in advance,

Regards,
Fred Hartman

Since last update a lot improvements with Z-wave has been done, my whole system is working with this. I'm really satisfied at the moment.

Hi Andrew,
I'm not working with ModBus but response time of support department could be improved.
Good luck with your problem.
Regards,
Fred